Dynamic RS bits are characterised by an ergonomically shaped mouthpiece. They lie perfectly in the horse's mouth resulting in soft and even pressure on the entire tongue area, encouraging the horse to chew. Dynamic RS bits stimulate the horse to accept the bit more easily.
These bits stimulate the horse to accept the bit more easily. In addition this bit supports the contact to the corners of the mouth in a very effective way, keeping the horse on the bit. The gentle joint in the middle which is angled forward - the characteristic feature of the KK ULTRA - and the fine eggbutt design makes it a very friendly bit.
The new DYNAMIC RS bit gives soft but very effective instructions for the better contact between horse and rider.
Ring sizes 65mm
measure a bit:
A bit should fit your horse’s mouth so that the mouthpiece extends approximately 1/4 inch (0.6 cm) beyond the horse’s lips on either side, but not so tight that the horse might be pinched by any movable cheek pieces. You also don’t want a great length of bit hanging out of the horse’s mouth. The different parts of the mouthpieces on bits are made to sit on specific areas of the mouth. So for the bit to be effective, the bit needs to contact those areas properly. You also don’t want the bit pulling through the horse’s mouth when you pull on a rein. Measure an old bit you know already fits. Use a tape measure to measure from the inside of each cheek piece or ring .Use a piece of string about 12” (30cm) long. Tie a knot about 2 inches (5cm) in. Put it through your horse’s mouth, with the knot against the lips on one side. Mark the opposite side with a marker or little piece of tape